Kenwood KAC-M3001
Compact mono subwoofer amplifier 300 watts RMS x 1 at 2 ohms

Kenwood’s KAC-M3001 compact mono subwoofer amplifier will power the bass in your vehicle with up to 300 watts RMS. That’s enough to hear the bass clearly above the noise of the road, trail, or waterway as you travel along. This little powerhouse will fit almost anywhere, including a storage compartment on a boat, motorcycle, or ATV, so you can put great bass in whatever vehicle you wish. Weather-resistant protection for music on the go. Conformal coating protects the internal circuits from water and dirt, so the show will always go on, even through the roughest conditions.

Product highlights:

• Mono subwoofer amplifier
• 200 watts RMS x 1 at 4 ohms (300 watts RMS x 1 at 2 ohms)
• CEA-2006 compliant
• Class D amp technology
• Conformal-coated circuit board — suitable for power sports and marine applications
• Variable low-pass filter (50-200 Hz, 24 dB/octave)
• Preamp and speaker-level inputs
• Fuse rating: 30A x 1
• 10-gauge power and ground leads recommended — wiring and hardware not included with amplifier
• Dimensions: 6-7/8″W x 1-13/16″H x 3-7/8″D
• Warranty: 1 year
• Our 30-day money-back guarantee
• MFR # KAC-M3001

Compact Amplifier: The Kenwood KAC-M3001 compact Class D mono block amplifier is designed to drive a subwoofer (or two). The amp features a conformal coating on the circuit board to protect it from moisture. This allows you to use the amp for motorcycles, marine applications, or on All-Terrain Vehicles (ATVs). The KAC-M3001 delivers 200 watts RMS x 1 channel at 4 ohms. It also gives you 300 watts RMS x 1 at 2 ohms.

Protection Circuitry: The amplifier features protection circuitry for thermal overload, DC offset, and short circuits. The amp stops operating when it goes into protection mode. (There are no LED indicators.)

Signal-sensing Turn-on: When the amplifier is connected to a factory head unit, or an aftermarket unit without preamp outputs, you can splice the head unit’s speaker wires to a speaker-to-male RCA adapter. In this case, the amplifier’s Signal-sensing Turn-on feature will turn on the amp when a signal is detected on the input. This eliminates the need to connect a turn-on lead to the amp’s Power Control (blue) wire.

Crossover: The amp has a low-pass crossover to filter out the high frequencies that a subwoofer is unable to reproduce. The crossover has a continuously variable crossover point (50 to 200 Hz) with a slope of 24dB/octave. The crossover cannot be turned off.